Crusher "strike" how to do

Strike, the machine will "strike". Due to improper operation or equipment quality, but off, or environmental factors, in the course of their work, the crusher will appear one way or another failure. Now the crusher models appearing on the market more, but the failures are common. Below on the possible failure of the crusher in the course of their work we do an analysis, how to listen to the experts of Red Star for your doubts.

Fault 1: main bearing temperature is too high.

Doubts: It may be the lack of grease, then you need to add the right amount of grease; grease pollution, then replace the bearings need to be cleaned grease; bearing damage, then you need to replace the bearings.

Fault 2: Discharge size is too large.

Doubts: It may be broken tooth wear excessive, then you need to replace the broken tooth or welding; side tooth wear or fall off, to be replaced.

Fault 3: crusher vibrations increase.

Doubts: It may be bearing damage, to be replaced; gear coupling is damaged, replace;

Fault 4: reduced processing capacity or lack of motivation.

Doubts: fluid coupling leaked, then supplement the quantitative No. 22 turbine oil or hydraulic transmission oil, if the coupling is broken needs to be replaced; uneven feed, then adjust the feed.

Fault 5: You can not be reversed.

Doubts: sensor is not installed correctly or damage, adjust or replace the sensor; sensor leads or wiring loose, turn on the lead or tighten the line.

Failure 6: Sensor protection system failure.

FAQ: proximity switch, then you need to replace damaged or loose wiring inside the cabinet added to the switch or wiring diagram line connected.

To the crusher to maintain a good working condition, ready to be put into operation, to reduce the incidence of failure, crusher, good rates and utilization, to extend the life of the crusher, the day-to-day care and maintenance of the crusher is indispensable, not only does not support, and just repair the raise. Always pay attention to the crusher equipment lubrication and maintenance, and bearing maintenance, prevention crusher "strike."