sand making equipment

Sand is the most important sand making equipment, the process of the first use, safe.Sand in security matters and routine maintenance
1 regular downtime to open observation door to observe the internal wear of the crusher, the center feed tube, cone cap, impeller, indecent Road liner, circular shield, wear block wear after wear should be timely replacement or repair, replacement The wear blocks should be replaced at the same time, wear the same block weight. To open observation door to observe the inner workings of non-crusher working process, to avoid danger. Found that the impeller body abrasion timely replacement looking for manufacturers to repair.

Pay special attention to, without the manufacturer's consent is strictly prohibited without permission homemade impeller, or peril.

Sand Mobilube adding proper amount of grease with grease of super or 3 # lithium grease, every 400 hours, 2,000 hours of work to open the bearing spindle assembly cleaning, general work 7200 hours, replaced with new bearings.

The upper end of the spindle assembly bearing is swimming side, the lower end of the bearing assembly fixed end pulled the pulley by hand should be flexible rotation.

3, the drive the triangle belt tensioner force size should be properly adjusted to ensure that the triangle belt force uniform, both sides of the triangle tape should be grouped optional dual motor drive, then each group of its length is as consistent as possible. Should be adjusted so that the difference between the two motor current does not exceed 15A.

4, the sand making machine is running, the device is a high-speed device, should pay special attention to safety in production. Should be kept away from the device, For machine repair should be carried out after the shutdown.